How to Measure your Cock Ring Size

To establish the correct ring size for your body, use the following methods…

Take measurements when fully erect

For Cock (shaft only) Ring

1) Take a string or cord and wrap it around your cock at its very base where it meets the body. Make it snug, but not too tight.

1a) Alternatively use a tailor’s cloth measuring tape and skip steps 2 and 3

2) Get a pen and mark the point on both sides where the string overlaps

3) Lay the string flat and measure the distance between the two points that you marked. This is your circumference

4) Divide the measurement by 3.14. This is your diameter

5) Deduct 6.5mm (1/4") from the diameter

6) The resulting diameter is the correct size for you.

For Cock and Ball Ring

1) Take a string or cord and wrap it underneath your balls and over your cock at its very base where it meets the body.Make it snug, but not too tight. A tailor’s tape is not advisable because it’s width will change the reading

2) Get a pen and mark the point on both sides where the string overlaps

3) Lay the string flat and measure the distance between the two points that you marked. This is your circumference

4) Divide the measurement by 3.14. This is your diameter

5) Deduct between 6.5mm (¼") and 12.5mm (½") from the diameter

6) The resulting diameter is the correct size for you.

According to statistics, the vast majority of men use either the 45mm (1¾") or 50mm (2") cock and ball rings

Please Note:
The purpose of a cock ring is to increase the erection, but not to cut off the blood supply. If you experience pain or discolouration, take the ring off immediately. If you cannot remove the ring due to the swelling try some lubricant or an ice pack. If this fails do not hesitate to go to the hospital emergency room. Don’t worry, they have seen it all before.

You can read on this subject in more detail in the Info drop-down menu. This is especially recommended to all newcomers, but old hands may learn something new as well